DESCRIPTION
FPDL-32
Standard Features
Housing
• Low profile steel housing contains, battery, battery charger, transfer
circuit and high frequency inverter
• Optional end caps available
• Operating temperature 68°F to 122°F (20°C to 50°C)
• Damp location listed
Mounting
• Slim Design, for internal or external mounting to a fluorescent fixture
Lamp Type Operation
• Most 2’-4’ T8, T12, 160, VHO lamps, refer to ballast/lamp reference
chart for specific lamp types
Lumen Output
• 2’-4’ Rapid, Instant, Energy Saving, T8 through T12
• T5 Lamps
• Long Compact Lamps
• Circline Lamps
Electronics
• Can be wired to operate switched, un-switched or normally off fixtures
without affecting normal operation
• Will cold start and illuminate lamps
• Fully Automatic solid state charger
• High capacity, automatic, dust-tight instantaneous transfer relay
• Low voltage disconnect prevents over discharge of battery
• Automatic brownout protection
• Battery connector prevents battery discharge during installation Controls
• Red charger monitor LED indicates charging of the battery and AC present
• Momentary test switch allows for quick operational check of entire
system
Sealed Maintenance-Free Battery
• Nickel-Cadmium battery
• Provides 90 minutes of emergency operation
Power Requirements
• Dual voltage 120/277VAC, 2.5W
Approvals
• UL 924 Standards
• Damp location listed
Warranty (subject to proper installation and maintenance)
• Ballast has a three year full warranty
This item can replace: I-32, B100, DEB-1W, UFO-3AW, FP450, C450, FPSI-32, FH7, L450, MF40-100, EFP 32GS, EFB40, FP-500LP, EP 500, FTU2485, XEB-55, AM32-L, PS300, PL4SC8, F40, S35F, UP40, FBP140X, FPSI-32